Lighting controller DMX is lighting software that will allow you to take effective care of all the special effects and lighting requirements of the night club / bar / lounge. It also may be used for organizing open air concerts and performances. Lighting controller DMX helps you create a unique ambience in the club. This software helps you take care of several DMX universes where each universe includes of up to 512 channels. In reality each DMX universe is assigned unique values starting from 0 to 255 and can have approximately 32 fixtures. This enables you to create control signals and transfer them to dimmer packs or lighting fixtures through wires by using a separate controller / PC operated controller.
Lighting controller DMX is a good option if applied in larger installations. In smaller installations all you need to do is switch on / switch off the power. Nevertheless, for more complex installations this may not be feasible since the wiring is far more complicated and you will need to run it back and from the booth. By opting for lighting controller DMX, all that you need to do is cable up to the breakers and from there on enable the wire lines to the booth. Therefore, you will have the ability to be in full control of the special effects and additionally the complete lighting in the night club / bar or even throughout an outdoor concert / show. The greatest part is it is possible to create a unique environment for the shows or the night club based on the requirements and stay in full control.
Lighting controller DMX may be used for a wide variety of special effects, fixtures and dimmer packs so long as they respond positively to its protocol. Lighting controller DMX is also subject to local laws. In some states / nations they restrict the use of DMX for truss movement equipment / moving stages / pyrotechnic effects. Avoid using the DMX controller if there is any risk to human life.
There are some details you should take into account when using lighting controller DMX. Make sure that the distance between the fixtures and the DMX wire is shorter. At the same time ensure that there is a fair distance in between energy wire and the DMX wires. If the wires interfere with each other, it can have a peculiar effect on the fixtures and additionally corrupt the DMX data.
Lastly, ensure that you maintain the fixtures correctly. Using a fiber glass contact cleaning pencil should make certain that the connector pins of the DMX controller is cleaned correctly so that it functions effectively at all times.